Eight considerations on wading agricultural vehicles

<

1. Agricultural vehicles should choose shallow water, hard bottom, slow slopes on both sides, and stable water flow.

2. If the flow speed of the agricultural vehicle wading is too rapid, it should be passed along the direction of the water flow. If the water surface is wide, the sign should be set to indicate the direction of travel, and trees, houses, power poles, etc., can also be selected as targets on the opposite bank.

3, when the wading depth exceeds the axle, should do all kinds of waterproof work. If you remove the fan belt, use a soft leather tube over the exhaust pipe and bend it upwards, wrap it with a waterproof cloth, and raise the battery to a certain position. If the water depth exceeds the maximum wading depth of the agricultural vehicle, you should not risk wading.

4, before wading, if the tire and brake hub temperature is higher, should be slightly rest, wait until it is properly cooled before launching.

5, when wading, should be smoothly into the water from the shore to splash water splash. In order to ensure that the engine has sufficient power, it should be passed at a uniform speed, avoiding stoppages, shifts, and jerk directions. Eyes must look at the target on the other side of the bank. Don't look at the water to avoid disturbing your vision and losing your direction.

6, wading in water, if agricultural vehicles slip idling, you should immediately stop, do not barely advance and retreat, but can not shout throttle, and to ensure that the engine does not turn off. Put stones, wood, etc. around the tires to strengthen the geological hardness and use other vehicles to assist in towing. If the bottom of the water is loose and loose sand, the engine should be turned off so as not to become deeper and deeper under the jitter of the engine. Human or other vehicles should be organized to assist in towing.

7. When passing through the flooded sandstone or mud road sections, it should be on the water side of the road and travel in a low gear. To prevent the erosion of the water stream on the water side, a large amount of earth and stone is lost, pits are formed, gaps are formed, and collapse occurs after being pressed to cause accidents.

8. When involving multiple agricultural vehicles, do not launch water at the same time. When the preceding vehicle arrives at the other shore, the vehicle will be driven into the water again to prevent the vehicle from stopping for any reason, forcing the rear vehicle to be stopped in the water.

Filter Production Line

filter,equipment,partition

ChangZhou FENGJU Machinery Equipment CO., LTD , https://www.czfengjumachinery.com