The hydrocyclone is a device for separating and removing substances such as heavier coarse-grained mud and sand in sewage, and is sometimes used for mud dewatering. Partial pressure and gravity type two kinds, often with a circular metal cylinder or tube production structures. The water enters the tangential line from the upper part of the structure (or metal tube) by pressure or gravity. Under the action of centrifugal force, the coarse and heavy particulate matter is thrown to the wall and rotated downward to discharge together with the formed concentrated liquid. The smaller particulate matter is rotated to a certain extent and then discharged with the secondary upper vortex. The hydrocyclone is a high-efficiency grading and desliming device. Because of its simple structure, easy manufacture and large processing capacity, it is widely used at home and abroad. Its main disadvantage is that it consumes a lot of power and is seriously worn during high pressure feeding. The use of new wear-resistant materials, such as cemented carbide, silicon carbide, etc., to make the grit and the wear-resistant parts of the ore, can partially solve this problem. In the process of grading and purifying quartz sand, the cyclone is mainly used for grinding classification, sorting, concentration and dehydration. 1. Grading in the grinding cycle system The hydrocyclone can be used for the classification of the coarse sand and overflow of the ball mill , as well as the pre-grading before the grinding operation. The obtained process index is almost the same as that of the mechanical classifier, and can basically replace the classifier work. Especially when the concentration of the slurry is large and the mechanical classifier cannot obtain a fine overflow, a hydrocyclone must be used. However, the hydrocyclone wears faster during the working process, and the lining needs to be replaced frequently, resulting in high equipment cost. If a high wear-resistant material is used as the lining, this problem can be solved. Second, the mud removal operation The hydrocyclone can be used for demineralization of various metal or non-metallic minerals: 1. Improve the selection index for the preparation work before the sorting operation 2. Remove the flotation agent on the ore particles 3. Remove coarse sand from non-metallic ore 4. Get the final concentrate Third, the concentration operation In some processes, due to the low concentration of the slurry, the design requirements are not met, and a cyclone is required for concentration treatment. Fourth, sand removal and impurity removal operations In the wet beneficiation process, after the ore is treated by the mashing process, quartz sand or impurities may be present in the slurry, so sand removal and impurity removal are prerequisites for the beneficiation process. Due to the different nature of the ore, it is sometimes possible to use a combination of different cyclones to achieve the process requirements. 5. Tailings filling and damming Fine sand of less than 37 microns in tailings cannot be used as material for tailings damming. Therefore, when using tailings to build dams, it must be classified by cyclone, coarse grades remain near the dam, and fine grades are tailed. The tail of the mine is flowing. At present, the tailings filling scheme is generally pre-concentrated and classified by a cyclone, and then dewatered by a filter to achieve the best effect. The hydrocyclone is not limited to the above operations, it can also be used to solve many other problems in the concentrator. In addition, cyclones can be used not only in the beneficiation industry, but also in the paper industry, construction, chemical industry and other industrial sectors. Commercial Fragrance Diffuser,Commercial Essential Oil Diffuser,Commercial Aroma Diffuser,Commercial Aroma Air Diffuser Guangzhou Chiyang Scent Technology Co., Ltd. , https://www.gzdiffuserscent.com