Two-Shot Injection,Double Shot Injection Molding,Short Shot Injection Molding,Two Shot Injection Molding Dongguan Kaisijin Intelligent Technology Co., Ltd , https://www.dgsmartlockoems.com
Many owners do not know how to install the sun and rain, and what details and points should be observed when installing the sun and rain? First understand the advantages and disadvantages of installing a sun and rain shield.
Teach you how to install the automobile sun and rain gear 1. Advantages:
1. Open the window when it rains to prevent the rainwater from directly pouring into the car to prevent the rainwater wiped by the wipers from blowing into the car.
2. When the window is shaken when you want to breathe, the air flow blown outside the car will not directly blow the face and affect the driving and passengers.
3. Can be shaded to prevent glare on the side from affecting the driving line of sight.
4. Avoid glare directly into the car, improve the car temperature.
5. Some people do not want to open the air on rainy days. Just open a small glass gap. The temperature difference between the inside and outside of the car is small, and the windshield surface inside the car will not fog.
6. For car smells such as smoke and heavy taste foods, the window only needs to open two or three centimeters, and the odor can be sucked out of the car, which is more effective than any air conditioning system.
7. When it is raining, the air is hot and you want to open the window to breathe, or you want to smoke. The sun and rain can allow you to open the window without getting wet from the rain.
Second, disadvantages:
1. Due to the fact that the shape of the sun visor and the shape of the outer edge of the window cannot be completely matched, defects such as warpage and subtle gaps are inevitable at the details. These details will be the root cause of insufficient wind noise and fastness to gluing. Therefore, the pursuit of perfection Riders please choose carefully;
2. After paving the sun and rain, it is very inconvenient for some riders to put ropes into the compartments to carry the luggage in the vehicle under certain circumstances. Because the ropes penetrated into the car are likely to be damaged. Sunny cover.
Third, the automobile sun visor principle is actually added a hut outside the window to ensure that it can also be ventilated on rainy days and does not allow rainwater to enter the windows. This is the most important role and it is very simple. The automobile sun visor to buy that kind of good to note here is that the clear or rainy ventilation effect is obvious and its shape is directly related, there is a sag design than the graphic design of the ventilation effect is better, when you buy can pay attention Take this detail.
Fourth, installation Follow the steps to teach everyone how to install the sun and rain.
1. Check the integrity of the sun visor after unpacking. 2. Wipe the window of the car with alcohol or the like and dip it with a hot air cylinder to ensure that the surface is free of dust, water, and oil.
3. Grasp the sun and rain shield with both hands and adjust it up and down to determine the frame of the sun visor to the window.
4. Tear a 3-5cm red film from the end of the double-sided tape (if the double-sided tape has two cuts, tear one of the other 3-5cm).
5. Grasp the sun and rain shield with both hands, determine the position of the frame of the sun visor on the window, and press down forcefully from the front 6. After 3-5cm sticks to the window frame, hold the other end with your hand to confirm the alignment of the window frame. The other hand slowly pulled the red film 7. After pulling 10cm or so, press the hand back and forth until the red film is pulled, and then press again from hand to hand.
8. Repeat steps 2-7 for each stick. Here, we must also remind you that installing the sun gear must be started from the end of the rearview mirror and installed in place once.