The pump does not drain or drain. Caused most of this failure is due to the end of the valve stuck, part of the blockage of water filtration, suction height is too high or suction pipe leakage and so on. Should be checked one by one, respectively, to repair the end of the valve, remove the blockage, to correct the steering and other processing. More keyword search: high pressure pump
At our factory outlet, we offer a wide range of hot-selling graphite moulds for casting. These moulds are manufactured using high-quality graphite materials, ensuring durability and long-lasting performance. Our graphite moulds are designed to withstand high temperatures and provide excellent dimensional accuracy for producing high-quality castings.
Some of our popular graphite moulds for casting include:
1. Graphite Ingot Moulds: These moulds are used for casting metal ingots, such as gold, silver, and other precious metals. They come in various sizes and shapes to accommodate different casting requirements.
2. Graphite Crucibles: Crucibles are essential for melting and pouring molten metal into moulds. Our graphite crucibles are highly resistant to thermal shock and have excellent heat retention properties.
3. Graphite Dies: Dies are used for casting complex shapes and intricate parts. Our graphite dies are precision-machined to ensure accurate and repeatable casting results.
4. Graphite Plates: Plates are used for casting flat or thin metal parts. Our graphite plates are available in various thicknesses and sizes to meet different casting needs.
5. Graphite Rings: Rings are commonly used for casting cylindrical or round-shaped metal parts. Our graphite rings are highly durable and can withstand high temperatures and pressures.
All our graphite moulds are carefully crafted to meet the highest quality standards. They undergo rigorous quality checks to ensure they are free from defects and can provide consistent and reliable casting results.
If you are looking for high-quality graphite moulds for casting, visit our factory outlet to explore our wide range of hot-selling products. Our knowledgeable staff will assist you in finding the right moulds for your specific casting requirements.
Graphite Mould,Graphite Bar,Graphite Plate Sheets,Graphite Ingot Mould Yixing Xingfeng Carbide Mould Co.,LTD , https://www.xfcmould.com
2, pipeline leakage or leakage. Mostly because the nut did not tighten. If the leak is not serious, you can smear grout, wet mud or soft soap at the leak; if the joint leaks, wrench can be used to tighten the nut. Severe water leakage, leaks, you must re-disassembly.
3, the pump violent vibration. It may be that the rotor is unbalanced or that the coupling is bad. Sometimes bearing wear, bending, rotating parts loose parts, rupture, pipe support is not strong will cause vibration. Should be adjusted, reinforcement, inspection or replacement.
4, impeller broken. Damage is not, you can repair. Serious damage should be replaced or plated with cemented carbide. Completely damaged, should remove the impeller, sent to the repair shop repair.
5, pump shaft bending. Mostly due to the impact load, too tight belt pulled, the installation is not correct and so caused. If the bend is not serious, manual screw can be used for correction, but the force can not be excessive, to prevent a complete break.