Electronic ergometer correct operation method Agricultural Spare Part,Disc Harrow,Mounted Disc Harrow,Agriculture Machinery Parts Ningbo COMBINE Machinery Co., Ltd. , https://www.combine-harvester-parts.com
At present, more and more users are using electronic dynamometers. Although many users will use it, but according to the correct operating sequence, there are still a lot of users do not do it. Today, the dynamometer Xiaobian for everyone to explain the number in detail Display the correct operating sequence of the force meter.
Â
Electronic ergometer correct operation method
1. Turn on the power first. After the power switch is turned on, the power indicator is on.
2. Need to wait for 15 minutes, wait until warm and stable before connecting with the computer.
3. Then we must select the appropriate load sensor to install and pull the digital pressure gauge sensor, adjust the required test speed, press the “Zero†button on the display to display zero.
 Â
4. Install the clamp connecting rod and start the "1" position switch. Adjust the "coarse adjustment" knob so that the panel meter reading is zero, then press the "50" file. Adjust the "fine adjustment" knob so that the display meter shows zero.
5. Press the "Calibration" block of the range switch and adjust the "Calibration" knob so that the readings on the panel meter are the same as those specified for the board. Finally press the "Zero" switch. Install the upper fixture holding the specimen, clamp the lower fixture, and then press the "50" stage, adjust the "fine adjustment" knob, so that the reading on the display instrument is zero. Press the force measurement to display the "over-force" "Power" switch, set the "range attenuation" and "test speed" and then open the recorder feed speed, press the "down" button on the speed unit panel to test.
6. After a sample has been tested on the side, the operation must be performed in the following order. The operation must be performed carefully.
7. Pull the digital display ergometer on the display and press the "Zero" key. On the speed indicator, press the Stop key.