Simply introduce the unloading steps for bulk cement tankers | powder and granular material carriers, and hope to help the majority of riders and friends. 1. Before discharge, check whether the unloading disc valve, the external air source interface, the exhaust valve, and the two inlets are closed and tightened. If they are not tightened, tighten them first to prevent air leakage. 2. Start the engine and shift the transmission to neutral. At the same time, depress the clutch pedal to completely separate the transmission from the engine. 3, open the power take-off solenoid valve switch, while slowly releasing the clutch pedal, so that the air compressor rotation; 4, adjust the operating mechanism of the operating handle, the air compressor speed adjusted to 900r/min or so, and stabilized; 5, when the pressure reaches 0.18MPa, first open the blowing pipe, and then open the front and rear warehouse discharge disc valve, start unloading, after which the air compressor pointer will stabilize a certain value; 6, when the pressure dropped to 0.04Mpa, after the warehouse has been unloaded, close the blowpipe, after opening and closing the disc valve a few times, and then the rear compartment valve and the rear compartment intake valve is closed, that is, only the front warehouse discharge After that, the pressure will rise and stabilize to a certain value; 7. When the pressure of the barometer reaches 0 MPa, the unloading is completed, the air compressor is turned off (closing the power switch), and the unloading disc valve is closed. Hubei Cheng Li Special Purpose Vehicle Co., Ltd., Sales Manager Chen Xin, Contact Tel: Welcome to visit us! Engine Piston Ring,Piston Ring,Compression Piston Ring,Car Piston Ring WUQIANG HONGMA TOOLS MANUFACTURE CO., LTD , https://www.hmfarmjack.com