The jigsaw hydraulic press structure is as follows:

Mainly by the frame, the upper beam, the lower beam, the mobile board, the main fuel tank, hydraulic system, electrical system, limit device, piping and other parts.

1. The body adopts a four-column structure and the structure is simple and compact, which is convenient for the operator to observe on all sides.

2. The main cylinder is a plunger-type cylinder with a quick cylinder inside, which can achieve rapid upward ascent and rapid pressure increase, thereby increasing production efficiency.

3. The cylinder is placed on the lower beam. When the cylinder is working, the motion mode is pressed from the bottom up.

4. The hydraulic system adopts the integrated form of hydraulic manifold oil circuit to realize the cyclical operation required by the process.

5. In addition to the front, back, left and right of the machine, four sets of grating protection are provided, and an emergency stop button is also provided to protect the operator's safety.

Jigsaw hydraulic press features:

1. Four-column structure, large table, travel according to customer requirements.

2. Equipped with safety light curtain protection before and after.

3. The pressure relay can easily set the pressure signal value manually.

4. The speed of idle stroke is fast, no speed and speed conversion, and direct pressure.

5. The mobile board presses up from below, not worrying about the danger of the sliding down.

Jigsaw hydraulic machine safety mechanism:

The hydraulic jigsaw machine has features such as large countertops, small openings and short trips. Large countertops, large workpieces, inconvenient handling by operators, coupled with small openings, bring great security risks to operators. For some of us, we designed the following security mechanisms:

1. Start for two-handed synchronization control. One hand cannot start.

2. Emergency stop switch can be emergency stop.

3. The hydraulic jigsaw is generally operated before and after, this machine is equipped with front and rear grating protection devices.

4. When the solenoid valve gets stuck, the solenoid valve gets out of control, which is very dangerous. The redundant design of the machine system effectively prevents the danger caused by the solenoid valve and provides a layer of safety protection.