The advantages of the fully automated CNC Spinning Machine (Spinmaster): The five most common types of car sensors parts:
The car sensor is the input device of the automobile computer system, it transforms the information of various working conditions, such as the speed, the temperature of the medium, the engine running condition, into the electric signal to the computer, so that the engine is in the best working condition. Car sensors are many, to determine the fault of the sensor, should not only consider the sensor itself, but should consider the entire circuit failure.
Sensor Auto Parts,Rear Wheel Speed Sensor,Speed Sensor,Wheel Speed Sensor Jinan Dingtai Auto Parts Co., Ltd. , http://www.dthavalparts.com
The use of rolled steel mesh can save 80% of field installation time.
By using rolled steel mesh, the floor and wall pavements are simpler, more efficient and faster. Because the diameter and spacing of the bars can be chosen, you can save the cost of the used steel bars.
By using Pedax's fully automated CNC Spinning Machine, you can quickly and economically produce the required reinforcement mesh on site. An important feature of this equipment is the ability to produce non-welded reinforcement mesh.
The metallurgical structure of the raw materials will not change, thus ensuring that the steel mesh can be installed in buildings subjected to alternating loads, such as bridges.
Peideke launches new fully automatic CNC mesh curtain machine
Peideke launches new fully automatic CNC mesh curtain machine
No welding required
Can be used to process all types of rebar (hot-rolled, cold-rolled);
By choosing the diameter and spacing of the bars themselves, you can save the cost of the used steel bar raw materials;
Highly flexible and easy to install;
The equipment is highly automated and requires only one person to operate.
1. Throttle position Sensor
The throttle position sensor is mounted on the throttle door to detect the throttle opening. It is connected with the throttle gate through the lever mechanism, and then reflects the different working conditions of the Engine Auto Parts. This sensor can be detected in different operating conditions of the engine input electronic control unit (ECU), so as to control the different fuel injection volume.
2. Inlet pressure sensor
The inlet pressure sensor can measure the absolute pressure in the intake manifold according to the load state of the engine, and convert the electrical signal and the rotational speed signal into the computer as the basis for determining the basic fuel injection quantity of the injector.
3. Crankshaft Position Sensor
Computer-controlled Ignition System is the most important sensor, its role is to detect the top stop signal, crank angle signal and engine speed signal, and input into the computer, so that the computer can be in the ignition sequence of the cylinder issued the best ignition time instructions.
4. Air Flow sensor
Air flow sensor is to convert the inhaled air into electrical signals sent to the electronic control Unit (ECU), as a decision to fuel injection of one of the basic signals.
5. Knock Sensor
The detonation sensor is installed on the cylinder of the engine to monitor the detonation of the engine at any time. At present, there are two kinds of resonant and non resonant type!
Pei Deke company introduced a new automatic CNC steel mesh curtain knitting machine
To meet the requirements of the non-welded steel mesh, Pei Deke (PEDAX) has introduced a new NC automatic knitting steel rolling machine (Spinmaster).
Related News: Machinery New Products Advantages