Welding Parts,Welding Fabrication,Welding Assembly,Cnc Machine Parts Dongguan Changsheng Technology Co., Ltd , https://www.dgcsmachining.com
Xc0049Â Pendulous Hydraulic Powered Cutting Machine
This machine is suitable for blanking of the nonmetallic materials such as small size knife mould, ticket clip units, handset sleeve, small toys, adornments, leather
bag fittings etc.
A. with freely rotary swing arm, easy to operate.
B.the upright column is made of high-grade seamless steel tube, strike board can turn smoothly, With
good reliability.
C.adopt the switches that are operated by two hands, to ensure the operator is safe.
D.the position of the swing arm is adjusted by the upper hand wheel on the machine, blanking travel is controlled by the timer, thus it is easy to obtain the best cutting position which can increase work efficiency and prolong the service life of the knife mould and becking board.
E.Use fly wheel stored energy to save energy.Â
Matters needing attentionÂ
1) moving workbench or spindle, according to the distance and artifacts, correctly selected movement speed, beware of collision when moving too fast.
2) when programming according to the actual situation to determine the correct processing technology and processing route, prevent due to insufficient processing position or on intensity artifacts caused by insufficient scrap or cut off the drop in advance.
Must be confirmed before 3) wire cutting program and the amount of compensation is correct.
4) check whether the wire electrode tension is enough. When cutting taper tension should be down to the usual half.
5) check the wire electrode of proper feeding speed.
6) according to the actual situation of work piece choose open or close the machining, on the premise of avoiding interference as far as possible to shorten the distance between nozzle and workpiece. The process, the distance between nozzle and workpiece generally take 0.05 ~ 0.1 mm.
7) check the jet choose whether reasonable, with high-pressure jet when rough machining, finish machining with low pressure jet.
8) slice observation should be paid attention to when processing stability, found that bad when adjust.
9) during processing, often should inspect the cutting condition monitoring, found the problem immediately.
Maximum momentum
80/100KN
Size of the working table
650×330mm
Range travel adjustment
5-75mm
Engine Power
0.75KW
Â