Overview of the operation of the 6M25 latest form compressor

<

The separator capacity of each section of the 6M25 compressor is too small, resulting in poor separation effect. A large amount of misty water is brought into the cylinder, which causes huge noise in the compressor cylinder, especially in the first, second and third sections. prominent. In this regard, the workshop strengthens management, requiring operators to discharge oil and water every 05h. At the same time, the oil pipes of the first and second sections of the compressor are separately led out of the normal row, and an overflow water seal is added at both ends of the inlet pipe of the compressor to remove the water in the semi-water gas. Separate the water; make an overflow water seal separately, connect the inlet water seal drain of each compressor to the overflow water seal, which is equivalent to adding a large separator to the inlet of each compressor. Adding a front point after the water seal basically ensures that a section of the compressor is not filled with water.

By adopting the above technical improvement measures, the situation that the first, second and third sections of the compressor are damaged and frequently replaced has been fundamentally reversed. The number of compressors has been reduced from more than 40 times per month to more than 10 times. It will directly increase the economic benefits for the company by more than 400,000 yuan.

(2) Circulating oil pump problem The circulating oil pump of the 6M25 compressor was originally installed in the upper part of the fuel tank. The depth of the suction pipe is not enough. When the oil level is low, it is easy to evacuate. To do this, change the position of the pump to the ground and the pump inlet is close to the bottom of the tank, but this will cause a jump due to low oil pressure.

(3) Oiler problem The gearbox of the original 6M25 compressor has a fast gearbox speed, and the number of oil-filled drops is not well adjusted. The adjustment is quick, and it is easy to make carbon deposits in the compressor cylinder and the water cooler; if it is lowered, it is easy to cause the oiler to not be oiled. For this purpose, all the oilers were replaced.

(4) The piston rod of each section of the compressor is easy to break. The safety margin of the piston rod of each section of the 6M25 compressor is not enough, and it is easy to break. There have been articles on this issue, and there is no more discussion here. The piston rod is broken. If it is not a dangerous part, as long as the parking is timely, the piston rod can be replaced. Otherwise, the crosshead will be damaged, resulting in greater economic loss; if the fracture is in a dangerous part, a large amount of inflammable and explosive gas will be removed from the cylinder. It is easy to catch fire and even a malignant blasting accident. In the old system piston compressor of our company, the gas was rushed out of the cylinder due to the broken piston rod, and a fire accident occurred. The entire compressor was completely scrapped. In this regard, it has been taken to increase the piston rod diameter of the compressor to reduce the possibility of piston rod breakage.

(5) Others found in the process of overhauling the 6M25 type compressor, because the pre-tightening force of the top wire of the fifth and sixth sections is not enough, it is easy to cause the sealing surface of the valve to be not tight, which has been improved accordingly.

Conclusion The 6M25 compressor has the characteristics of easy fault diagnosis and convenient maintenance. The body is cast as a whole, with good balance, and the lifting of the spindle is convenient. Since the 6M25 compressor only has a balance chamber in six stages, the internal circulation of the gas is reduced, so that the amount of gas is large and the power consumption is small. Although there are some shortcomings in its auxiliary machines, as long as the partial transformation, strengthening management, and maintenance work are carried out according to the actual situation, it is possible to achieve long-term and stable operation.

Cheap X Banner

Cheap X Banner,Cheap X Banner Stands,Adjustable X Display Banner,X Banner Stand Display

SUZHOU JH DISPLAY&EXHIBITION EQUIPMENT CO.,LTD , https://www.jh-snapframe.com